Wingtip Issue

For my fuel vents I used the combination of the JD air parts vents, and an andair (bleeding type) check valve.

So this means that the wingtip has a U shape cutout for the vent.

I put the port wingtip on after paint, and the small piece of fiberglass between the vent aft broke (I should have known better).  It's usually about a 1" strip between the counterweight slot and the wing.  The U shape cutout means its less.  Far less.

Cut that piece off and it is now permanently attached to the airframe.

Will add a picture one day when i remember to take one.